Reboot/Shutdown; Manage Data - 3Com SuperStack 3 NBX Administrator's Manual

380 C 7: O
HAPTER PERATIONS

Reboot/Shutdown

Manage Data

Additional considerations:
When you upgrade the system software, do not enter any "cd..."
■
commands using the terminal emulation software on a PC attached to
the NBX Network Call Processor.
Do not use the browser until the upgrade is complete. The upgrade
■
may take a few minutes. When the software upgrade is complete, a
new window, containing a confirmation message, appears in the NBX
NetSet utility.
At certain times during an upgrade, the Network Call Processor (NCP)
■
reboots itself. Do not interrupt the NCP; wait until the upgrade is
complete.
Before you upgrade your system software, 3Com recommends that
■
you back up your system data. (See "Backup" later in this chapter.)
After you upgrade your system software, you must reboot the system.
■
To upgrade or remove software, select Operations > Software Upgrade.
See the Help for procedures on upgrading or removing software.
You must reboot the system after you upgrade software. You must shut
down the system software before you turn off power to your NBX
system.
To reboot or shutdown the system, select Operations >
Reboot/Shutdown.
See the Help for procedures on rebooting and shutting down the system.
This section describes about these system data management operations:
Backup
■
Restore
■
Convert Database
■
Purge Database
■
Purge Database and CDR
■
To perform data management operations, select Operations > Manage
Data. See the Help for procedures on managing your system data.