3Com SuperStack 3 NBX Administrator's Manual page 81

Configuring VPIM Parameters Using the NBX NetSet Utility
Table 16 Operations Management Dialog Box Fields
Field
Operations status
Number of outgoing
messages
Outgoing Messages
Time Waiting
# Attempts
Sender
Destination
Remove
Apply Buttons
Send all messages now The NBX system attempts to send all messages immediately
Send all messages now
and then delete them
Delete all messages
now
Stop operations
Start operations
Purpose
The status of the queue of outgoing voice mail messages.
Possible values: Starting, Ready, Processing, Stopped.
The number of messages in the outgoing queue when this
dialog box was last accessed or refreshed.
The number of minutes that the voice mail message has
been waiting in the queue.
The number of times the NBX system has attempted to
send the voice mail message.
The e-mail address of the user who sent the voice mail
message.
The IP address and extension to which the voice mail
message is to be sent.
NOTE: You must stop the message queue before you can
remove any message.
Select a voice mail message in the scroll list and click this
button to remove the message from the queue. The NBX
system prompts you to confirm that you want to delete the
selected message.
Use Shift+Click to select a block of messages, or Ctrl+Click
to select several messages that are not in a single block.
and then waits for the required number of minutes (see
Table 15) before making another send attempt.
The NBX system makes a single attempt to send each
message on the queue.
Any undelivered messages are returned to sender with
delivery failure notices, and then deleted from the outgoing
mail queue.
The NBX system deletes all messages from the outgoing
mail queue.
These messages are not returned to sender with delivery
failure notices.
Stops the queue if it is currently active.
Starts the queue if it is stopped.
81