3Com SuperStack 3 NBX Administrator's Manual page 456

456 A B: ISDN C
PPENDIX
Table 80 Completion Cause Codes (continued)
Class Grouping Hex Code
0x53
0x54
0x55
0x58
0x5B
0x5F
Protocol error 0x60
0x61
0x62
0x63
C C
OMPLETION AUSE ODES
Decimal
Code Description
83 Suspended call
exists, call
identity does
not
84 Call identity in
use
85 Incompatible
destination
88 Incompatible
destination
91 Transit network
does not exist.
95 Invalid message
(unspecified)
96 Mandatory IE
missing
97 Nonexistent
message
98 Wrong
message
99 Bad info
element
Details
A call resume has been attempted with a call identity
that differs from that in use for any currently
suspended calls.
The network has received a call suspended request
that contained a call identity (including the null call
identity) that is already in use for a suspended call
within the domain of interfaces over which this call
may be resumed.
The equipment sending this cause has received a
request to establish a call that has low layer
compatibility, high layer compatibility, or other
compatibility attributes (for example, data rate) that
cannot be handled.
Reports an invalid message event only when no other
cause in the invalid message call applies.
The equipment sending this cause has received a
message that is missing an information element that
must be present in the message before that message
can be processed.
The equipment sending this cause has received a
message with a message type that it does not
recognize, either because it is an undefined message,
or it is defined but not implemented by the equipment
sending the cause.
The equipment sending this cause has received a
message that it considers as nonpermissible while in
the call state; or a STATUS message was received
indicating an incompatible call state.
The equipment sending this cause has received a
message that includes information elements not
recognized because the information element identifier
is not defined, or it is defined but not implemented by
the equipment sending the cause. However, the
information element is not required to be present in
the message to enable the equipment sending the
cause to process the message.