Configuring Vtl Passwords In The Dial Plan - 3Com NBX 100 Administrator's Manual

96 C 2: D P
HAPTER IAL LAN
Configuring VTL For each remote NBX system that controls hop-off by means of a VTL
Passwords in the password, you must configure that password into the VTL commands in
Dial Plan the local dial plan.
If you use site codes to access other NBX systems through VTL
connections, you can configure one set of VTL connections that permit
hop-off and are accessed one set of site codes. You can configure
another set of VTL connections that do not permit hop-off and are
accessed using a different set of site codes.
If you use unique extension ranges at each site, and therefore do not dial
a site code when placing VTL calls to users at those sites, you can still use
codes to access VTL connections that permit hop-off at the far end.
Figure 16 shows how to configure VTL passwords in a dial plan, using site
codes that permit hop-off and other site codes that do not. Each entry is
explained following the figure.