3Com SuperStack 3 NBX Administrator's Manual page 203

Table 31 Attendant Console Button Mappings (continued)
Button Type
CLIR-All
CLIR-Next
Switch to DTMF
Configuring the NBX 1105 Attendant Console
Description
Assigns Calling Line Identity Restriction to this button.
When you press the button, all subsequent ISDN calls
made by from this telephone no longer contain calling
party information.
If the button has a light beside it, pressing the button
causes the light to turn on.
To turn off CLIR-All, press the button again. The light
turns off.
Normally, when an ISDN call is made, the identity of the
caller is provided to the PSTN and may be seen by the
called user if they subscribe to the Caller-ID service. CLIR
allows you to withhold this information from the called
user.
NOTE: Enabling CLIR-Next does not cause the lamp to
light.
Number — Not used.
Prty (Priority) — Not used.
Assigns Calling Line Identity Restriction to this button.
When you press the button, the next ISDN call made
from this telephone does not contain calling party
information.
If the button has a light beside it, pressing the button
does not cause the light to turn on.
After you complete the call and hang up, CLIR-Next
becomes inactive.
Normally, when an ISDN call is made, the identity of the
caller is provided to the PSTN and may be seen by the
called user if they subscribe to the Caller-ID service. CLIR
allows you to withhold this information from the called
user.
Number — Not used.
Prty (Priority) — Not used.
Enables this button to switch the currently active call
from pulse dialing to DTMF.
NOTE: This applies only to calls made using Analog Line
Card ports.
203