3Com SuperStack 3 NBX Administrator's Manual page 234

234 C 3: D
HAPTER EVICE
C
ONFIGURATION
Table 41 describes each field in the dialog box.
Table 41 Analog Terminal Adapter - Advanced Settings Parameters
Field
MAC Address
Audio Level Controls
Audio Input Gain (dB)
Audio Output Gain (dB)
Purpose
The factory-assigned MAC address for the 4-Port
Analog Terminal Card or the Analog Terminal Adapter.
NOTE: The ports on a 3C10114 4-Port Analog
Terminal Card have sequential MAC addresses.
The ports on a 3C10114C 4-Port Analog Terminal Card
have the same MAC address, and a Virtual Device
Number (VDN), in square brackets after it, provides a
unique identifying number to each port.
Set this value to control the volume of the audio signal
from the analog telephone attached to this ATA or
ATC port.
Default: Depends on the country in which the NBX
system is operating. When you load a regional pack
(Operations > Regional Software) and select the tones
and cadences appropriate for your location
(System Configuration > System Settings >
Regional Settings > Advanced), the default value is set.
Minimum: - 10 dB
Maximum: + 10 dB
Mute is a choice provided for testing purposes.
Set this value to control the volume of the audio signal
sent to the analog telephone attached to this ATA or
ATC port.
Default: Depends on the country in which the NBX
system is operating. When you load a regional pack
(Operations > Regional Software) and select the tones
and cadences appropriate for your location
(System Configuration > System Settings >
Regional Settings > Advanced), the default value is set.
Minimum: - 10 dB
Maximum: + 10 dB
Mute is a choice provided for testing purposes.