The machine does not transmit
Status
Cannot transmit
Are you transmitting correctly?
Is the destinaion number correct?
Is the type of phone line set
correctly?
Is there something wrong with the
other machine?
Documents are
Are the documents loaded with the
not transmitted
edges of the paper all line up?
continuously
Do the loaded documents include
pages smaller than the minimum
width (4.72 in)?
Cannot transmit
Is the type of phone line set
even if dialing the
correctly?
number
Is the document loaded correctly?
Is the phone number correct?
Is the other party's line busy?
Cannot transmit
Did you press the <Start> key after
manually
putting down the handset?
The document
Is the document loaded correctly?
cannot be scanned
Is the memory full?
in case of memory
transmission
Check item
Check the procedure and try again.
If you are using the speed-dial, make sure the
number is registered correctly by printing out
the list.
Make sure all settings should match the phone
line properties.
Ask the other party to prepare the machine for
reception. (power, paper, etc.)
Reload the document.
These pages should be set on the document
glass and kept separate from the other pages.
Make sure all settings should match the phone
line properties.
Load the document correctly.
Dial the correct number.
Wait until the line is available and try again.
Press the <Start> key before putting down the
handset.
Set the document correctly.
Check the memory.
Troubleshooting
Countermeasure
●
In This Case...
Maintenance and Troubleshooting
Getting
Started
COPY
Chapter1
COPY
Chapter2
Reference page
COPY
3-8
Chapter3
3-213
FAX
1-59
Chapter1
FAX
–
Chapter2
1-49
FAX
Chapter3
1-49
FAX
Chapter4
1-59
FAX
Chapter5
1-49
–
–
SCAN
3-13
Chapter1
SCAN
1-49
Chapter2
–
SCAN
Chapter3
Function
Settings
In This
Case...
Appendix
6-43