Printing Area; Automatic Paper Supply Function - Muratec MFX-2350 User Manual

Getting
Started

Printing area

The area image shown below cannot be printed.
Area (A) that is 0.12 in. (3mm) ±0.07 in. (2mm) (when evenly magnifi ed) from the front edge of the paper.
Area (B) that is 0.12 in. (3mm) ±0.07 in. (2mm) (when evenly magnifi ed) from the back edge of the paper.
Area (C) that is 0.12 in. (3mm) ±0.07 in. (2mm) (when evenly magnifi ed) from the edge of the paper.
Reference
The blank margin around the paper can be changed. (page 5-35)

Automatic paper supply function

If the paper from the currently selected paper supply tray runs out during printing, the machine
automatically switches to the appropriate cassette and continues printing. If the large capacity
cassette is installed, continuous printing or copying can be performed for a maximum of 3,650
sheets. (For Letter paper)
■
Paper supply changing order
If the automatic paper supply function is operating, the paper cassettes and trays are selected with the following
priority.
Paper cassette 1
Reference
If the bypass tray is used in the automatic paper supply function, the machine must be set to "Select Print Cassette". (page 5-28)
Note
If special paper, such as OHP fi lm or label sheets, is loaded in the bypass tray, the automatic paper supply function could
activate causing the wrong paper to be supplied. In this case, it is recommended that the paper type should be set to other
than plain paper in the bypass paper setting. (page 1-45)
1-34
Getting Started
Paper discharge direction
Paper cassette 2 Paper cassette 3
A, B, C: 0.12 in. (3mm) ±0.07 in. (2mm)
(When evenly magnifi ed)
Paper cassette 4 Bypass tray