Error Code - Muratec MFX-2350 User Manual

In This
Case...

Error code

D: Dialing Errors
Mode Error code
D.0.2
D.0.3
D.0.6
D.0.7
T: Transmission Errors
Mode Error code
T.1.1
T.1.4
T.2.1
T.2.2
T.2.3
T.3.1
T.3.2
T.4.1
T.4.2
T.4.4
6-30
●
In This Case... Maintenance and Troubleshooting
Description of code
Receiving line is busy
The <Stop> key was pressed
The receiving fax number is not regis-
tered when using the auto-dial function
The receiving party did not answer
when using the auto-dial function
Description of code
Wrong number (receiving party
answered and hung up)
The receiving party answered
manually and hung up the phone
The other party's machine is not a
G3 machine
The <Stop> key was pressed when
starting the communication (only
displayed in the auto print journal)
The line status was bad (especially
when communicating overseas) and
the receiving party cut off the line
Your machine's settings do not
match with the other machine's
Your machine's settings do not
match with the other machine's
Due to a line error, communication is
not available even at the slowest speed
In a consecutive transmission, the pages
from the second page caused a read error
A document of which length is
longer than 900 mm was transmit-
ted
Brightness in the lamp is insuf-
fi cient if "Lamp error. Call for serv-
ice" is displayed after transmission
is interrupted
Due to a line error, communication
failed.
Due to a line error, the receiving
party disconnected the line during
document transmission
An image quality error occurred
at the receiving party (due to line
error)
The line is disconnected during docu-
ment transmission (due to a line error)
Countermeasure
Resend the document.
Resend the document.
Set the correct fax number and then resend the docu-
ment.
Set the correct fax number and then resend the docu-
ment.
Countermeasure
Check the correct fax number and resend the document.
Check how the receiving party should receive a fax.
This machine cannot communicate with it.
Resend the document.
Resend the document. If this error occurs repeatedly,
contact your Muratec dealer.
Check the settings on the other machine. If the receiving
party has special settings, ask him/her to release them.
Check the settings on the other machine.
Resend the document. If this error occurs repeatedly,
contact your Muratec dealer.
Resend the document starting from the page that caused
the error.
Cut the length of a page into 900 mm or less, and resend.
T urn the power from OFF to ON and try to copy. If the
error message "Check lamp." does not appear, resend
the document. If the error message "Check lamp." ap-
pears even in case of copying, contact your Muratec
dealer.
Resend the document. If this error occurs repeatedly,
contact your Muratec dealer.
Resend the document. If this error occurs repeatedly,
contact your Muratec dealer.
All pages were received but some of them might have
had poor image quality. Ask the receiving party to check
the quality of the document.
Resend the document.