Logging In; Wss Configuration Settings - Nortel 2340 Configuration Manual

Wlan - location engine using interfaces

Hide thumbs Also See for 2340:

Table of Contents

22 Connecting to WLAN Location Engine 2340 through Initial Administration GUI

Logging in

The first attempt to access any GUI page redirects to a login page; the individual with overall system administration

privileges (typically the person with root privileges) can enter a secure user name and password. After the initial installa-

tion, a login screen is displayed once per session.

Note.

credentials, it means that Cookies are not enabled for the browser. In order to be able to log

in, you need to enable Cookies on the browser.

Note.

WLE2340.

WLE2340 detects location APs, once you perform the following steps:

Steps to set static ip address for APs:

#set ap <ap_number> boot-configuration switch mode enable

#set ap <ap_number> boot-configuration switch switch <switch IP address>

#set ap <ap_number> boot-configuration ip <ap_static_ip_address> netmask <netmask> gateway

<gateway IP address> mode enable

Steps to set snoop mapping (recommand snap-length is 100):

#set snoop <snoop name> oberserver <WLE-2340_ip_address> snap-length <snap-length>

#set snoop map <snoop name> ap <ap_number> radio <1 or 2>

#set snoop <snoop name> mode enable

You can use these commands to check snoop setting:

#show snoop stats

#show snoop info

NN47250-504 (324122-A Version 01.01)

If you get the security check error 'HTTP Status 400' when you try to enter your

In WSS, you have to first configure a static IP address for an AP to enable it in

Table of Contents