Installation - Nortel 1110 Fundamentals

434 Expansion Module for IP Phone 1100 Series
Prompt Response
CLS KEM3
KEY 0 - <see
text>/<CR>
PAGEOFST <Page> <KeyOff-
set> / <CR>
KEY <key> <keys conf data>/
<CR>
KEMOFST <KEM> <Key-Off-
set> / <CR>
KEY <key> <keys conf data>/
<CR>

Installation

The Expansion Module mounts on the right side of the IP Phone. The
Expansion Module snaps into the receptacle on the back of the IP Phone
using the desk-mount bracket and structural baseplate supplied with the
Expansion Module.
The Expansion Module connects to the IP Phone using the Accessory
Expansion Module (AEM) port on the IP Phone.
Use
(page 435)
to the IP Phone.
Copyright © 2003–2007, Nortel Networks
.
Description
KEM3 CLS must be defined
Key number range expanded to support number of
Expansion Modules specified by KEM prompt. The range
on the IP Phone is as follows:
KEM value:
0
1
2
3
PAGEOFST is prompted if one Expansion Modules is
specified at the KEM prompt and <CR> is entered at the
KEY prompt. This prompt enables you to enter a Page
number of 0, or 1, and a Key Offset number from 0 to 17.
Once entered, the KEY is prompted with the appropriate
KEY value filled in. <CR> ends the input.
<key> is the key number for the Page + Key Offset entered
at PAGEOFST. Enter the key configuration <CR> or just
<CR>.
KEMOFST is prompted if two or three Expansion Modules
are specified at the KEM prompt and <CR> is entered for
KEY prompt.
This prompt enables you to enter a KEM number of 1, 2, or
3 and a KEY Offset number from 0 to 17. Once entered,
the KEY prompt is prompted with the appropriate KEY
value filled in. <CR> ends the input.
<key> is the key number for the KEM + Key Offset entered
at KEYOFST. Enter the key configuration <CR> or just
<CR>.
Procedure 87 "Connecting the Expansion Module to the IP Phone"
to connect the Expansion Module for IP Phone 1100 Series
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 02.01 Standard
Release 5.0 7 December 2007
KEY range:
0 to 31
32 to 49
50 to 67
68 to 85