Configuring The Ip Phone 1140E; Installation And Configuration; Before You Begin; First-Time Installation - Nortel 1110 Fundamentals

368 Nortel IP Phone 1140E
Argentina
1.8 m (5.9 ft), 10 amp, IEC320-C13
Japan
Installation and configuration
The following sections provide a step-by-step guide to install and configure
the IP Phone 1140E
•
•
•
•
•

Before you begin

Before installing the IP Phone 1140E, complete the following pre-installation
checklist
•
•
•
•

First-time installation

You must first install an IP telephony node with the Communication Server.
For information about installing an IP telephony node, see Signaling Server
Installation and Commissioning (NN43001-312) or IP Line Fundamentals
(NN43100-500).
Copyright © 2003–2007, Nortel Networks
.
"Before you begin" (page 368)
"First-time installation" (page 368)
"Configuring the IP Phone 1140E" (page 369)
"Startup sequence" (page 374)
"Installing the IP Phone 1140E" (page 374)
Ensure one IP Phone 1140E boxed package exists for each IP Phone
1140E you install. The package contains
— IP Phone 1140E
— handset
— handset cord
— 2.1 m (7-ft) CAT5 Ethernet cable
— Number plate and lens
— Getting Started Card
Ensure one Software License exists for each IP Phone 1140E you install.
Ensure the host Call Server is equipped with a Voice Gateway Media
Card and a Signaling Server with the Line TPS application.
If an AC power adapter is required, ensure the approved Nortel global
power supply (model number N0089601) is used. See
Phone 1140E component list" (page
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 02.01 Standard
Release 5.0 7 December 2007
N/A A0814961
NTTK26AAE6 N/A
Table 48 "IP
367).