Nortel 1110 Fundamentals page 376

376 Nortel IP Phone 1140E
3
4
5
6
7
8
9
10
11
Copyright © 2003–2007, Nortel Networks
.
Use the Right navigation key to scroll and highlight Enable 802.1x
(LLDP Enable). check box.
For information about 802.1x Authentication, see
Link Layer Discovery Protocol" (page
Use the Right navigation key to scroll and highlight DHCP list.
Press the Enter key.
Press the Down navigation key to open list box.
Use the Up/Down navigation keys to scroll and highlight one of the
following DHCP options
• No—disable DHCP support and enter IP network information
manually.
• Partial—IP network information (IP address, network mask, and
gateway address) are provided by the DHCP server. Enter
Server 1 IP address, Server 2 IP address, Port, Action, Retry,
and PK numbers manually.
• Full—IP network information, Server 1 IP address, Server 2 IP
address, and XAS information are provided by the DHCP server.
All items are dimmed to prevent manual entry.
A DHCP server and DHCP relay agents must also be installed,
configured, and running if you choose Partial DHCP, or Full DHCP
configuration.
For more information about how to set up DHCP servers for use
with the IP Phones, see Converging the Data Network with VoIP
Fundamentals (NN43001-260).
Press the Enter key.
Use the Right navigation key to scroll and highlight SET IP. Press
the Enter key to start the edit mode. Use the dialpad to fill in the
information:
Set IP—a valid IP Phone 1140E IP address
Use the Right navigation key to scroll and highlight NET MASK.
Press the Enter key to start the edit mode. Use the dialpad to fill
in the information:
Net Mask—a subnet mask
Use the Right navigation key to scroll and highlight Gateway. Press
the Enter key to start the edit mode. Use the dialpad to fill in the
information:
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 02.01 Standard
Release 5.0 7 December 2007
Appendix "802.1ab
471).