Tftp Firmware Upgrade - Nortel 1110 Fundamentals

426 Nortel IP Phone 1150E
7
8
When the IP Phone restarts, the firmware reads the setting for Full Duplex
mode and sets the LAN Ethernet port, PC Ethernet port, duplex, and speed
accordingly.
Use the following procedure to confirm activation of Full Duplex mode.
Procedure 83
Checking Ethernet Statistics
Step
1
2
TFTP firmware upgrade
When you enter the IP address of the TFTP Server, the IP Phone searches
for an upgrade file on the TFTP Server.
Users of CS 1000 Release 4.5 or later do not need to enter a TFTP IP
address.
For further information about TFTP firmware upgrade, see
Server" (page
Copyright © 2003–2007, Nortel Networks
.
Press Enter to exit the edit mode.
Press the Apply&Reset soft key to save the changes and to restart
the IP Phone 1150E. The firmware settings are read and are applied
to UPLINK and the PC Ethernet Port.
Action
Double-press the Services key to open the Local Tools menu.
Press 2 to select Local Diagnostics, then press 3 to open the
Ethernet Statistics menu.
If Full Duplex mode is active, the following is displayed
•
Link Status: UP
• Duplex Mode: Full
•
Network Speed: 10 MB, 100 MB, or 1 G
• Auto Sense/Negotiate
— Auto-Negotiate Capability: No
— Auto-Negotiate Completed: No
547).
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 02.01 Standard
Release 5.0 7 December 2007
—End—
—End—
Appendix "TFTP