Nortel 1110 Fundamentals page 148

148 Nortel IP Audio Conference Phone 2033
Procedure 26
Installing the IP Audio Conference Phone 2033 for the first time using manual
configuration
Step
1
2
3
4
Copyright © 2003–2007, Nortel Networks
.
Action
When the Nortel logo appears in the middle of the display,
immediately press the three soft keys at the bottom of the display in
sequence from left to right.
At the prompt, DHCP Yes/NO?, enter 0 (0 for No).
By default, Full DHCP is configured on the IP Audio Conference
Phone 2033. Depending on the configuration requirements, you can
change the IP Audio Conference Phone 2033 configuration to allow
the following IP address assignments:
• Static—enter all parameters
•
Partial DHCP—IP Phone address, subnet mask, and default
Gateway are obtained from the DHCP server
•
Full DHCP— (default) all parameters are obtained from the
DHCP server
A DHCP server and DHCP relay agents must also be installed,
configured, and running if you choose Partial DHCP, or Full DHCP
configuration.
For more information about how to set up DHCP servers for use
with the IP Phones, see Converging the Data Network with VoIP
Fundamentals (NN43001-260).
Enter the following information:
Screen prompt
set IP
net msk
def g w
The TFTP Server is required to download the current firmware. For
further information about TFTP Server configuration, see
"TFTP Server" (page
Enter the information for the primary Connect Server (S1) and the
secondary Connect Server (S2):
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 02.01 Standard
Release 5.0 7 December 2007
Description
a valid IP Audio Conference Phone 2033
IP address
a subnet mask
the default Gateway for the
IP Audio Conference Phone 2033 on the
LAN segment to which it connects.
547).
Appendix