Nortel 1110 Fundamentals page 373

9
10
11
12
Copyright © 2003–2007, Nortel Networks
.
CAUTION
Damage to Equipment
Do not plug any device into your IP Phone 1140E PC
Ethernet port other than a PC. The IP Phone 1140E does
not support multiple devices connected through the PC
Ethernet port.
Connect additional cables. If applicable, plug in optional USB
devices. Connect the Ethernet cable to the LAN Ethernet connection.
If you are using an AC power adapter, plug the adapter into an
AC outlet.
Complete steps 1 to 9, as needed, before wall-mounting the IP
Phone.
Wall-mount your phone (optional). Use Method A or Method B to
wall-mount the IP Phone. See Method A—using the mounting
holes on the bottom of the phone stand, or Method B—using the
traditional-style wall-mount box with a CAT5 connector and a 15 cm
(6 inch) CAT5 cord (not provided).
• Method A: Press the wall-mount lever, and pull away from the
stand. Using the stand cover (see
holes by pressing the bottom of the stand cover firmly against
the wall in the location where you wish to install the phone. Four
small pins on the bottom of the stand cover make the marks on
the wall. Use the marks as a guideline to install the wall-mount
screws (not provided).
Install the screws so that they protrude 3 mm (1/8 inch) from the
wall, and then install the phone stand mounting holes over the
screw heads. You may need to remove the phone from the wall
to adjust the lower screws. When the lower screws are snug,
install the phone on the mounting screws, and then tighten the
top screws.
• Method B: Attach the 15 cm (6 inch) CAT5 cable, position the
stand over the mounting rivets, and slide the phone down the
wall so that the rivets fit into the slots on the stand.
Replace the stand cover. Ensure that all cables are neatly routed
and press the stand cover into place until you hear a click.
If you wall-mount the phone, put it in the wall-mount position by
holding the tilt lever and press the phone towards the base until the
phone is parallel with the base. Release the tilt lever and continue
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 02.01 Standard
Release 5.0 7 December 2007
Installation and configuration 373
step 3), mark the wall-mount