Ip Phones Fundamentals; Nn43001-368 02.01 Standard - Nortel 1110 Fundamentals

5
6
7
8
9
10
Copyright © 2003–2007, Nortel Networks
.
•
soft key 4 is Cancel
When prompted: TFTP Dwnld? (0-No, 1-Yes):0,
•
Press soft key 2 (BKSpace) to clear the 0 (No).
• Press 1 on the dialpad, then press soft key 1 (OK).
When prompted: TFTP IP xxx.xxx.xxx.xxx,
• If the IP address is correct for the TFTP server, press soft key
1 (OK). After the TFTP address is entered the first time, it is
presented the next time you enter the menu.
•
If the IP address is incorrect, press soft key 2 (Clear) to erase
the address shown and enter a new address. Press the asterisk
(*) key to enter a period (.) in the IP address. You can also use
backspace key to erase part of the address or correct errors by
pressing soft key 1 (BKSpace). When the address is correct,
press soft key 1 (OK).
The phone reads the configuration file from the TFTP server, extracts
the Server_IP and Filename fields, and attempts to download the
file. The display shows the message [FW] reading...
The display shows [FW] writing... and the blue LED starts to flash.
After the FW image is written to the phone, the message [FW]
finished is displayed, the blue LED stops flashing, and the phone
resets.
The phone registers to the TPS with the new FW version.
If the TFTP Server, specified by the TFTP IP address entered during
configuration, is unreachable or down, the IP Phone attempts to
register to the TPS to perform a firmware download. If the IP Phone
does not register to the TPS, the IP Phone does not work. Check
the TFTP IP address and the state of the TFTP Server, then reboot
the IP Phone.
If the IP Phone remains in this condition because no TPS FW
download occurs, check the TFTP IP address and the state of the
TFTP Server, then restart the IP Phone.
Nortel Communication Server 1000

IP Phones Fundamentals

NN43001-368 02.01 Standard

Release 5.0 7 December 2007
Updating IP Phones firmware 555
—End—