Nortel 1110 Fundamentals page 45

Copyright © 2003–2007, Nortel Networks
.
VLANFILTER (0-N, 1-Y)
Ctrl pBits (0-7, 8-Au)
Media pBits (0-7, 8-Au)
PCUntagAll? (0-N, 1-Y)
PSK SRTP? (0 for No, 1 for Yes)
GARP Ignore? (0-No,1-Yes)
The IP Phone 2001 supports remote firmware upgrades through a
TFTP process and an automated UFTP process.
You are prompted to enter the TFTP Server IP address if you are
using a TFTP Server to download the current firmware.
The method to upgrade the firmware depends on the following Call
Server software:
• For Succession Release 3.0 or CS 1000 Release 4.0, the TFTP
Server is required to download the current firmware. Enter the
TFTP Server IP address at the prompt.
•
For CS 1000 Release 4.5, use either a TFTP Server to upgrade
the firmware (at the prompt accept the default entry of 0.0.0.0) or
UFTP to download the current firmware.
• For CS 1000 Release 5.0 and later, a Signaling Server provides
the firmware for the IP Phones. Check the Nortel Web site at
www.nortel.com
For Succession Release 3.0 and CS 1000 Release 4.0, the IP Phone
2001 searches for the TFTP Server for firmware upgrade. If the file
name specified in i2001.cfg is not the same as the current firmware,
the IP Phone downloads the file and upgrades the firmware. This
takes several minutes. When the upgrade is complete, the IP Phone
2001 reboots.
For further information about TFTP Server configuration, see
Appendix "TFTP Server" (page
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 02.01 Standard
Release 5.0 7 December 2007
Installation and configuration 45
Default 0 (for No).
You are not prompted for
VLANFILTER if VLAN is not
enabled.
Default 8 (for Auto).
You are not prompted for Ctrl pBits
if 802.1Q is not enabled.
Default 8 (for Auto).
You are not prompted for Media
pBits if 802.1Q is not enabled.
Default 0 (for No).
Default 0 (for No).
Default 0 (for No).
for updated firmware files.
547).