Nortel 1110 Fundamentals page 41

5
6
7
Copyright © 2003–2007, Nortel Networks
.
At the prompt DHCP Yes/No?, enter 0-N (0 for No). You are
prompted to enter all parameters.
By default, Full DHCP is configured on the IP Phone 2001.
Depending on the configuration requirements, you can change
the IP Phone 2001 configuration to allow the following IP address
assignments:
• Static—enter all parameters
• Partial DHCP—IP Phone address, subnet mask, and default
Gateway are obtained from the DHCP server
•
Full DHCP— (default) all parameters are obtained from the
DHCP server
A DHCP server and DHCP relay agents must also be installed,
configured, and running if you choose Partial DHCP, or Full DHCP
configuration. For more information about how to set up DHCP
servers for use with the IP Phones, see Converging the Data
Network with VoIP Fundamentals (NN43001-260).
Enter the following information:
Screen prompt
set IP
net msk
def gw
Enter the information for the primary Connect Server (S1) and the
secondary Connect Server (S2):
S1 IP
S1 Port
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 02.01 Standard
Release 5.0 7 December 2007
Installation and configuration 41
Description
A valid IP Phone 2001 IP address.
A subnet mask.
The default Gateway for the IP Phone 2001 on
the LAN segment to which the IP Phone 2001
connects.
The primary CS 1000 node IP
address for the IP Phone 2001.
This is a fixed value: 4100