Nortel 1110 Fundamentals page 145

4
5
Copyright © 2003–2007, Nortel Networks
.
Figure 14 "POE module" (page
Ethernet cable into your IP network interface.
Connect the CAT5 Ethernet cable attached to the PoE module to the
IP Phone. Thread the CAT5 Ethernet cable through the channel on
the bottom of the IP Phone and plug it into the PoE module port on
the IP Phone.
Connect the AC power adapter (optional) to the power supply port
located on the back of the PoE module, Leave the AC power adapter
unplugged from the power outlet. Thread the cord through the
channel on the bottom of the PoE module then plug the other end
into the AC power source. Ensure you use the correct AC power
transformer. The voltage rating of the transformer must match the
wall outlet voltage. See
CALA, AP, and GC" (page 141)
EMEA" (page 142).
Figure 14 "POE module" (page 145)
(PoE) module.
Figure 14
POE module
Red LEDs on the IP Audio Conference Phone 2033 indicate power.
Messages indicating system start up, such as Loading, Initializing
network, and Loading boot parameters appear after a short delay.
Figure 15 "Bottom view of IP Audio Conference Phone 2033" (page
146) shows the bottom view of the IP Audio Conference Phone 2033.
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 02.01 Standard
Release 5.0 7 December 2007
Installation and configuration 145
145). Plug the other end of the CAT5
Table 15 "Components list for US, CA,
or Table 16 "Components list for
shows the Power over Ethernet