Installation And Configuration; Getting Started Card - Nortel 1110 Fundamentals

40 Nortel IP Phone 2001
Power transformer 2-prong wall plug direct plug-in AC to AC, 8 W,
240 VAC, 50 Hz, to 16 VAC at 500 mA (Australia and New Zealand)
Power transformer AC to AC, direct plug-in, 8 W, 100 VAC, 50 Hz,
to 16 VAC at 500 mA
For more information, and for information about previous versions of the IP
Phone, contact your Nortel representative.

Installation and configuration

The following sections provide a step-by-step guide to install and configure
the IP Phone 2001:
•
•
•
•
•
Before you begin
Before installing the IP Phone 2001, complete the following pre-installation
checklist:
•
•
•
•
Copyright © 2003-2007, Nortel Networks
.
Before you begin
First-time installation
Configuring the IP Phone 2001
Startup sequence
Installing the IP Phone 2001
Ensure one IP Phone 2001 boxed package exists for each IP Phone
2001 being installed. The package contains:
- IP Phone 2001
- handset
- handset cord
- 2.1 m (7-ft) CAT5 Ethernet cable
- Getting Started Card
Ensure 1 Software License exists 1 for each IP Phone 2001 being
installed.
Ensure the host Call Server is equipped with a Signaling Server that
runs the Line Terminal Proxy Server (LTPS) application.
If an AC power adapter is required, ensure you use the correct AC power
transformer. The voltage rating of the transformer must match the wall
outlet voltage. See Table 4 "IP Phone 2001 components list" (page
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 01.02 Standard
Release 5.0 20 June 2007
A0647042
A0828858
39).