First-Time Installation; Configuring The Ip Audio Conference Phone 2033 - Nortel 1110 Fundamentals

144 Nortel IP Audio Conference Phone 2033
•

First-time installation

You must first install an IP telephony node with the Communication Server.
For information about installing an IP telephony node, see Signaling Server
Installation and Commissioning (NN43001-312), or IP Line Fundamentals
(NN43100-500).
Configuring the IP Audio Conference Phone 2033
Use
(page 144)
Procedure 25
Configuring the IP Audio Conference Phone 2033
Step
1
2
3
Copyright © 2003–2007, Nortel Networks
.
If an AC power adapter is required, ensure you use the correct AC power
transformer. The voltage rating of the transformer must match the wall
outlet voltage. See Table 15 "Components list for US, CA, CALA, AP,
and GC" (page 141)
CAUTION
Service Interruption
Do not plug your IP Audio Conference Phone 2033 into an ISDN
connection. Severe damage can result.
Procedure 25 "Configuring the IP Audio Conference Phone 2033"
to configure the IP Phone 2001 for the first time
Action
Configure a virtual loop on the system using LD 97.
For more information about configuring a virtual loop, see IP
Line Fundamentals (NN43100-500) and Software Input Output
Administration (NN43001-611).
Configure the IP Audio Conference Phone 2033 on the system using
LD 11. At the prompts, enter the following:
REQ:chg
TYPE:2033
TN cc uu
ECHG yes
ITEM cls
ITEM
For more information about configuring the IP Audio Conference
Phone 2033 using LD 11, see Software Input Output Administration
(NN43001-611).
Connect one end of the CAT5 Ethernet cable to the network interface
located on the back of the Power over Ethernet (PoE) module. See
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 02.01 Standard
Release 5.0 7 December 2007
or Table 16 "Components list for EMEA" (page 142).