Startup Sequence; Installing The Ip Phone 1150E - Nortel 1110 Fundamentals

Startup sequence

When an IP Phone 1150E connects to the network, it must perform a startup
sequence. The elements of the startup sequence include
•
•
•
•
See
of the IP parameters and how they are obtained.
Table 58
IP Phone 1150E IP parameters
Parameter
VLAN ID
IP Address
Net Mask
Default Gateway address
Connect Server (IP address, port,
action and retry count—primary
and secondary)
User ID (Node ID, Node Password
and TN)

Installing the IP Phone 1150E

To install the IP Phone 1150E, use
1150E " (page
Copyright © 2003–2007, Nortel Networks
.
phone is parallel with the base. Release the tilt lever and continue
to push the phone towards the base until you hear a click. Ensure
the phone is securely locked in to position.
obtaining VLAN ID (if supported by the network infrastructure)
obtaining the IP parameters
connecting to the Call Server
obtaining a User ID
Table 58 "IP Phone 1150E IP parameters" (page 415)
Method of acquisition
Manually entered or automatically obtained through DHCP,
and LLDP.
Manually entered or automatically obtained through Partial
or Full DHCP.
Manually entered or automatically obtained through Partial
or Full DHCP.
Manually entered or automatically obtained through Partial
or Full DHCP.
Manually entered or automatically obtained through Full
DHCP.
Manually entered for first-time configuration. Obtained from
local storage on subsequent power cycles.
416).
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 02.01 Standard
Release 5.0 7 December 2007
Installation and configuration 415
—End—
Procedure 81 "Installing the IP Phone
for a summary