Before You Begin; First-Time Installation; Configuring The Ip Phone 1110 - Nortel 1110 Fundamentals

290 Nortel IP Phone 1110

Before you begin

Before installing the IP Phone 1110, complete the following pre-installation
checklist
•
•
•
•

First-time installation

You must first install an IP telephony node with the Communication Server.
For information about installing an IP telephony node, see Signaling Server
Installation and Commissioning (NN43001-312) or IP Line Fundamentals
(NN43100-500).
Configuring the IP Phone 1110
You must configure the IP Phone 1110 before you can use it. Use Procedure
58 to configure the IP Phone 1110 for the first time.
Procedure 57
Configuring the IP Phone 1110
Step
1
Copyright © 2003–2007, Nortel Networks
.
Ensure one IP Phone 1110 boxed package exists for each IP Phone
1110 you install. The package contains
— IP Phone 1110
— handset
— handset cord
— 2.1 m (7-ft) CAT5 Ethernet cable
— number plate and lens
— Getting Started Card
Ensure one Software License exists for each IP Phone 1110 you install.
Ensure the host Call Server is equipped with a Signaling Server that
runs the Line TPS application.
If an AC power adapter is required, ensure the approved Nortel AC
adapter (model number N0089601) is used. See
1110 components list" (page
CAUTION
Do not plug your IP Phone 1110 into an ISDN connection. Severe
damage can result.
Action
Configure a virtual loop on the Call Server using LD 97.
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 02.01 Standard
Release 5.0 7 December 2007
Table 38 "IP Phone
288).