Nortel 1110 Fundamentals page 52

52 Nortel IP Phone 2001
Copyright © 2003–2007, Nortel Networks
.
DHCP (0-No, 1-Yes)
VLANFILTER (0-No, 1-Yes)
Duplex? (0-Auto, 1-Full)
Ctrl pBits (0-7, 8-Au)
Media pBits (0-7, 8-Au)
PCUntagAll? (0-N, 1-Y)
PSK SRTP? (0 for No, 1 for Yes)
GARP Ignore? (0-No,1-Yes)
The IP Phone 2001 supports remote firmware upgrades through a
TFTP process and an automated UFTP process.
You are prompted to enter the TFTP Server IP address if you are
using a TFTP Server to download the current firmware.
The method to upgrade the firmware depends on the following Call
Server software:
• For Succession Release 3.0 or CS 1000 Release 4.0, the TFTP
Server is required to download the current firmware. Enter the
TFTP Server IP address at the prompt.
• For CS 1000 Release 4.5 and later, use either a TFTP Server to
upgrade the firmware (at the prompt accept the default entry of
0.0.0.0) or UFTP to download the current firmware.
•
For CS 1000 Release 5.0, a Signaling Server provides the
firmware for the IP Phones. Check the Nortel Web site at
www.nortel.com
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 02.01 Standard
Release 5.0 7 December 2007
Default 0 (for No).
If you select 1 (1 for Yes), the VLAN
ID is configured automatically to
a value received from the DHCP
server.
You are not prompted for DHCP if
VLAN is not set to Auto (2-Au), or if
DHCP is not enabled.
Default 0 (0 for No).
You are not prompted for
VLANFILTER if VLAN is not
enabled.
Default 0 (for Auto).
Default 8 (for Auto).
You are not prompted for Ctrl pBits
if 802.1Q is not enabled.
Default 8 (for Auto).
You are not prompted for Media
pBits if 802.1Q is not enabled.
Default 0 (for No).
Default 0 (for No).
Default 0 (for No).
for updated firmware files.