Introduction; Description - Nortel 1110 Fundamentals

354 Nortel IP Phone 1140E

Introduction

This section explains how to install and maintain the IP Phone 1140E. For
information about using the IP Phone 1140E, see the IP Phone 1140E
User Guide (NN43113-106) or the IP Phone 1140E Getting Started Card
(NN43113-103).
This section contains the following procedures
•
•
•
•
•
•
•
After you install and configure an IP Phone, if power to the phone is
interrupted, you need not re-enter the IP parameters, node number,
Terminal Number (TN), or reacquisition of firmware.

Description

The IP Phone 1140E uses the customer IP data network to communicate
with the Communication Server 1000 (CS 1000) . The IP Phone 1140E
translates voice into data packets for transport using Internet Protocol.
Use a Dynamic Host Configuration Protocol (DHCP) server to provide
information that you can use for the IP Phone 1140E network and CS
1000 connections.
Figure 37 "IP Phone 1140E" (page 355)
Copyright © 2003–2007, Nortel Networks
.
Procedure 73 "Configuring the IP Phone 1140E" (page
Procedure 74 "Installing the IP Phone 1140E" (page
Procedure 75 "Enabling Full Duplex mode" (page
Procedure 76 "Checking Ethernet Statistics" (page
Procedure 77 "Changing the TN of an existing IP Phone 1140E" (page
386).
Procedure 78 "Replacing an IP Phone 1140E" (page
Procedure 79 "Removing an IP Phone 1140E from service" (page
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 02.01 Standard
Release 5.0 7 December 2007
369).
375).
384).
385).
387).
shows the IP Phone 1140E.
388).