Installing The Ip Phone 1110 - Nortel 1110 Fundamentals

296 Nortel IP Phone 1110
•
•
SeeTable 39 "IP Phone 1110 IP parameters" (page 296)
the IP parameters and how they are obtained.
Table 39
IP Phone 1110 IP parameters
Parameter
VLAN ID
IP Address
Net Mask
Default Gateway Address
Connect Server (IP address, port,
action and retry count—primary and
secondary)
User ID (Node ID, Node Password and
TN)

Installing the IP Phone 1110

To install the IP Phone 1110, use the following procedures
•
•
Installing the IP Phone 1110 using manual configuration
Timing information
There are approximately 30 seconds between plugging in the IP Phone 1110
power adapter and the appearance of the text Nortel. When you see the text
Nortel on the phone, you have 1 second to respond by pressing the four soft
keys at the bottom of the display in sequence from left to right, one at a time. If
you miss the 1-second response time, the IP Phone 1110 attempts to locate
the connect server. You can begin the power-up sequence again, or you can
double-press the Services key to open the Local diagnostic utilities to access the
IP Phone settings. See
Copyright © 2003–2007, Nortel Networks
.
connecting to the Call Server
obtaining a User ID
Method of acquisition
Manually entered or automatically obtained through DHCP,
and LLDP.
Manually entered or automatically obtained through Partial
or Full DHCP.
Manually entered or automatically obtained through Partial
or Full DHCP.
Manually entered or automatically obtained through Partial
or Full DHCP.
Manually entered or automatically obtained through Full
DHCP.
Manually entered for first-time configuration. Obtained from
local storage on subsequent power cycles.
Installing the IP Phone 1110 for the first time using manual configuration
Installing the IP Phone 1110 for the first time using DHCP
Appendix "IP Phone diagnostic utilities" (page
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 02.01 Standard
Release 5.0 7 December 2007
ATTENTION
for a summary of
483).