Replacing An Ip Phone 1140E - Nortel 1110 Fundamentals

2
3
4
5
6

Replacing an IP Phone 1140E

Two IP Phones cannot share the same TN. You must remove the IP Phone 1140E
that currently uses the TN.
Procedure 78
Replacing an IP Phone 1140E
Step
1
2
3
Copyright © 2003–2007, Nortel Networks
.
If the node password is enabled and NULL, choose one of the
following
a. Disable the password.
b. Set the password as non-NULL.
Press OK when the node number displays.
If
the node password is enabled and
is not NULL
the node password is disabled
Enter the password at the password screen, and press OK.
A TN screen displays.
To obtain the password, enter the nodePwdShow command in
Element Manager. For further information, see Element Manager
System Reference—Administration (NN43001-632).
Select the Clear soft key to clear the existing TN.
Enter the new TN.
Action
Obtain the node and TN information of the phone you want to
replace.
Disconnect the IP Phone 1140E that you want to replace.
Follow Procedure 73 "Configuring the IP Phone 1140E" (page
369) to install and configure the IP Phone 1140E.
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 02.01 Standard
Release 5.0 7 December 2007
Replacing an IP Phone 1140E 387
Then
a password screen displays. Go to
Step 4.
a TN screen displays. Go to
—End—
ATTENTION
Step 5.