Table of Contents
Advertisement
Chapter 3
IP Phone installation
Complete the procedures in this chapter to
•
prepare the IP Phone for installation
•
install the IP Phone
•
wall-mount the IP Phone
•
install the expansion module
For more detailed IP Phone installation procedures, see the Telephony Device Installation Guide
for your BCM system.
Prerequisites
•
Ensure you have the following components:
— IP Phone 1210, 1220, or 1230
— foot stand
— handset
— handset cord
— 2.1 m (7 ft) CAT5 Ethernet cable
•
If you are wall-mounting an IP Phone, ensure you have the following tools:
— Phillips or flat-head screwdriver, depending on the type of screws you have
— two screws
— pen or pencil
— measuring tape
•
Ensure you have one software license for each IP Phone being installed.
Navigation
•
"Attaching the foot stand (optional)" on page 26
•
"Connecting the handset" on page 27
•
"Connecting the headset (optional)" on page 27
•
"Connecting the power (optional)" on page 28
CAUTION
Risk of service loss
Do not plug your IP Phone into an ISDN connection. Severe damage can
result. The IP Phone does not support multiple devices connected
through the PC Ethernet port.
IP Phone 1200 Series Installation
25
Advertisement
Table of Contents
