Nortel 1110 Fundamentals page 117

8
9
10
Timing information
There are only four seconds between plugging in the IP Phone 2004 power
transformer and the appearance of the Nortel logo in the middle of the display.
When you see the logo, you have one second to respond by pressing the four soft
keys at the bottom of the display in sequence from left to right, one at a time. If
you miss the one-second response time, the IP Phone 2004 attempts to locate
the connect server. You can begin the power-up sequence again, or you can
double-press the Services key to open the network diagnostic utilities to access
the IP Phone settings. See
Copyright © 2003–2007, Nortel Networks
.
the IP Phone downloads the file and upgrades the firmware. This
takes several minutes. When the upgrade is complete, the IP Phone
2004 reboots.
For further information about TFTP Server configuration, see
Appendix "TFTP Server" (page
The Enhanced UNIStim firmware download is supported on CS 1000
Release 4.5 or later. The Enhanced UNIStim firmware download
feature for IP Phones improves the delivery of new firmware to IP
Phones. For further information about Enhanced UNIStim Firmware
Download, see IP Line Fundamentals (NN43100-500).
For information about the IP Phone firmware upgrade using Element
Manager, see Element Manager System Reference—Administration
(NN43001-632).
The IP Phone 2004 can support primary (S1) and secondary (S2)
connect server. If you require IP Phones to register on multiple
nodes, see IP Line Fundamentals (NN43100-500).
The IP Phone 2004 searches for the connect server.
Enter the following information
The IP Phone 2004 registers with the TPS and, if needed, begins the
firmware download. This takes several minutes. When registration is
complete, the IP Phone 2004 resets.
The current Call Server date and time appear on the top line of the
display when the configuration is complete. Self-labeling keys also
appear.
Check for a dial tone and the correct DN above the display.
(Optional) Customize the feature keys as required. For more
information, see IP Phone 2004 User Guide (NN43117-102).
Appendix "IP Phone diagnostic utilities" (page
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 02.01 Standard
Release 5.0 7 December 2007
Installation and configuration 117
547).
—End—
ATTENTION
483).