Nortel 1110 Fundamentals page 82

82 Nortel IP Phone 2002
9
10
Timing information
There are only 4 seconds between plugging in the IP Phone 2002 power
transformer and the appearance of the Nortel logo in the middle of the display.
When you see the logo, you have 1 second to respond by pressing the four soft
keys at the bottom of the display in sequence from left to right, one at a time. If
you miss the 1-second response time, the IP Phone 2002 attempts to locate
the connect server. You can begin the power-up sequence again, or you can
double-press the Services key to open the network diagnostic utilities to access
the IP Phone settings. See
To edit network configuration, the following soft keys are available:
•
•
•
•
Procedure 11
Installing an IP Phone 2002 for the first time using DHCP
Step
1
2
3
Copyright © 2003–2007, Nortel Networks
.
The current Call Server date and time appear on the top line of the
display when the configuration is complete. Self-labeling keys also
appear.
Check for a dial tone and the correct DN above the display.
(Optional) Customize the feature keys as required. For more
information, see IP Phone 2002 User Guide (NN43116-104).
OK—accept current settings and proceed to the next configuration
option. If all configuration options are presented, the configuration is
saved and the IP Phone reboots with the saved changes.
BkSpace—erase a configuration entry to change it
Clear—clear an entire configuration entry
Cancel—cancels network configuration. The IP Phone reboots without
saving changes.
Action
When the Nortel logo appears in the middle of the display,
immediately press the four soft keys at the bottom of the display in
sequence from left to right.
At the prompt EAP Enable?, enter 1-Yes (1 for Yes) if the network
infrastructure supports 802.1x port-based network access control.
Enter DeviceID and Password.
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 02.01 Standard
Release 5.0 7 December 2007
—End—
ATTENTION
Appendix "IP Phone diagnostic utilities" (page 483).