Nortel 1110 Fundamentals page 83

4
5
6
7
Copyright © 2003–2007, Nortel Networks
.
If you select No, you are not prompted to enter Device ID and
Password.
For more information about EAP, see
network access control" (page
At the prompt, LLDP Enable?, enter 1-Y (1 for Yes, default).
For more information about LLDP, see
Discovery Protocol" (page
see Appendix "802.1Q VLAN description" (page
At the prompt DHCP Yes/No?, enter 1-Y (1 for Yes).
By default, Full DHCP is configured on the IP Phone 2002.
Depending on the configuration requirements, you can change
the IP Phone 2002 configuration to allow the following IP address
assignments:
• Static—enter all parameters
• Partial DHCP—IP Phone address, subnet mask, and default
Gateway are obtained from the DHCP server
• Full DHCP— (default) all parameters are obtained from the
DHCP server
A DHCP server and DHCP relay agents must also be installed,
configured, and running if you choose Partial DHCP, or Full DHCP
configuration.
For more information about how to set up DHCP servers for use
with the IP Phones, see Converging the Data Network with VoIP
Fundamentals (NN43001-260).
At the prompt, Cached IP?, select 0 (0-No, default) to conform to the
DHCP standard and to obtain an IP address from the DHCP server.
Select 1 (1 for Yes) to force the IP Phone to start with a cached IP
address if the IP Phone cannot connect to the DHCP server and
obtain an IP address.
Select Partial or Full DHCP.
a. If you select Full DHCP, then the following parameters are
retrieved from the DHCP server:
• a valid IP Phone 2002 IP address
• a subnet mask
• the default Gateway for the IP Phone 2002 on the LAN
segment to which it connects
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 02.01 Standard
Release 5.0 7 December 2007
Installation and configuration 83
Appendix "802.1x Port-based
469).
Appendix "802.1ab Link Layer
471). For more information about 802.1Q,
461).