First-Time Installation; Configuring The Ip Phone 1120E - Nortel 1110 Fundamentals

332 Nortel IP Phone 1120E
•
•

First-time installation

You must first install an IP telephony node with the Communication Server.
For information about installing an IP telephony node, see Signaling Server
Installation and Commissioning (NN43001-312) or IP Line Fundamentals
(NN43100-500).
Configuring the IP Phone 1120E
You must configure the IP Phone 1120E before you can use it. Use
Procedure 65 "Configuring the IP Phone 1120E" (page 332)
IP Phone 1120E for the first time.
Procedure 65
Configuring the IP Phone 1120E
Step
1
2
Copyright © 2003–2007, Nortel Networks
.
Ensure the host Call Server is equipped with the a voice Gateway Media
Card and a Signaling Server with the Line TPS application.
If an AC power adapter is required, ensure the approved Nortel global
power supply (model number N0089601) is used. See
Phone 1120E components list" (page
CAUTION
Do not plug your IP Phone 1120E into an ISDN connection.
Severe damage can result. The IP Phone 1120E does not support
multiple devices connected through the PC Ethernet port.
Action
Configure a virtual loop on the Call Server using LD 97.
For more information about configuring a virtual loop, see IP
Line Fundamentals (NN43100-500), and Software Input Output
Administration (NN43001-611).
Configure the IP Phone 1120E on the Call Server using LD 11. At
the prompt, enter the following
REQ:chg
TYPE: 1120
For more information about configuring the IP Phone 1120E using
LD 11, see Software Input Output Administration (NN43001-611).
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 02.01 Standard
Release 5.0 7 December 2007
Table 43 "IP
330).
to configure the