Adj 12.6-171 Booklet Compiling Position - Xerox ColorQube 9303 Series Service Manual

Front tamper Paper sheet
Figure 1 Observing the tamper positions.
Repairs/Adjustments
ADJ 12.5-171, ADJ 12.6-171
Paper sheet
Rear tamper
Booklet maker staplers
February 2013

ADJ 12.6-171 Booklet Compiling Position

Purpose
To set the compiling position to ensure correct compiling without damage. When the compiling
position is correctly set, each sheet is fed behind the BM entry roll to rest against the right side
of the compiler.
Procedure
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to GP
death or injury. Moving parts can cause injury.
Go to the appropriate check and adjustment from the following options:
• If only A4 paper is available, go to
• If only 8.5 X 11 inch paper is available, go to
A4 Paper Procedure
Check
1. Open the HVF BM front door and insert an interlock cheater into the front door interlock
switch.
2. Fully pull out the BM module and release the jam clearance handle
open the paper guide PL 12.150 Item
3. Enter Diagnostic Routine dC330
backstop to raise to the receive position (where it will pause), select Stop.
4. Insert a single sheet of A4 paper short edge downward into the booklet maker compiling
area, so that it rests on the backstop and is approximately central front to back. Tuck the
top of the sheet behind the BM entry roll,
5. If the BM right hand cover does not have a viewing hole, remove the BM right hand cover,
REP 12.56-171.
4-406
WARNING
14. Disconnect the power cord. Electricity can cause
A4 Paper Procedure.
8.5 X 11 Inch Procedure.
PL 12.150 Item
7.
code 12-255 BM Backstop Motor, select Start, allow the
PL 12.150 Item 15.
ColorQube® 9303 Family
8, fully