Xerox ColorQube 9303 Series Service Manual page 1136

2. Before installing a new camshaft, ensure that the slot in the drive gear is aligned with the
slot in the machine frame, Figure 2.
1
Ensure the driver gear is aligned
with the slot in the machine
frame.
2
Align the camshaft with the slot in
the machine frame. Ensure the
longer side of the drive pin is
pointing to the right.
Figure 2 Camshaft alignment
3. Ensure that the black cam on the new camshaft points towards the rear of the machine.
Align the drive pin with the slot in the drive gear, longer side pointing to the right. Press
the camshaft into the drive gear until the pin is fully seated,
Repairs/Adjustments
REP 91.32
4.
1
Place the washer on the shaft, then lower the
shaft into place. Ensure the cam lock is seated
correctly and that the washer is seated cor-
rectly in the frame.
Figure 2.
February 2013
4-378
Lower the camshaft into place at the front of the machine. Align the washer with the
machine frame, at the same time as aligning the locating tags on the bottom of the lock
mount with the holes in the machine frame,
Figure 3 Camshaft relocation
Figure 3.
2
Cam lock locator and hole.
ColorQube® 9303 Family