Xerox ColorQube 9303 Series Service Manual page 824

11. Remove the rear transfix linkage and gear,
1
Remove the retract spring
Figure 7 Rear transfix linkage removal
Repairs/Adjustments
REP 10.3
Figure 7.
2
Remove the rear transfix linkage
Replacement
1. Replacement is the reverse of the removal procedure.
NOTE: Before tightening the screws,
removed in Figure 4.
2. Ensure that the arm is in the correct position relative to the gear.
3. Ensure that the spring is re-installed.
4. Cross out the old calibration value from the calibration label on the front outer frame,
10.20 Item 19, Figure 8.
5. Write the calibration values of the new linkage on the calibration label.
6. Perform dC978 Transfix Calibration Values and load the correct values for the new link-
age.
February 2013
4-66
Figure 5, it may be necessary to position the bushes
Calibration label for front and
rear transfix calibration values
Figure 8 Calibration label
ColorQube® 9303 Family
PL