Rep 12.12-171 Bin 1 Elevator Motor Assembly - Xerox ColorQube 9303 Series Service Manual

4. Remove the front tamper assembly,
NOTE: The front tamper home sensor is removed to prevent the sensor from being dam-
age when the front tamper assembly is removed.
1
Disconnect and remove
the home sensor.
4
Remove the front tamper 3
assembly.
Remove 5 screws to release the
support bracket.
Figure 2 Front tamper assembly
Replacement
Reverse the removal procedures to reinstall the front tamper motor assembly.
Repairs/Adjustments
REP 12.11-171, REP 12.12-171
Figure 2.
2
Disconnect the away
sensor harness.

REP 12.12-171 Bin 1 Elevator Motor Assembly

Parts List on PL 12.105.
Removal
Take care during this procedure. Sharp edges may be present that can cause injury.
Switch off the electricity to the machine. Refer to
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
1. Remove the front and rear covers
2. Remove the rear drive belt lower pulley to relieve the belt tension.
3. Remove the bin 1 elevator motor assembly
NOTE: The pulley pin may fall when the pulley is removed.
3
Release the wiring
from the clamps.
Figure 1 Stacker Motor Gearbox Assembly
Replacement
Reverse the removal procedures to reinstall the bin 1 motor elevator motor assembly.
NOTE: Check that the 'flats' on the shaft bearing align with the cut-outs in the bracket.
Check that the Bin 1 lift bar is level before refitting the stacker belt lower pulley.
February 2013
4-136
WARNING
WARNING
GP 14. Disconnect the power cord
REP 12.1-171.
Figure 1.
1
2
Remove the circlip, the
Remove the
upper pulley and the pin.
bearing.
ColorQube® 9303 Family