Xerox ColorQube 9303 Series Service Manual page 985

REP 12.83-171 Inserter Front and Rear Covers
Parts List on PL 12.300.
Removal
Take care during this procedure. Sharp edges may be present that can cause injury.
Switch off the electricity to the machine. Refer to
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
1. Undock the Inserter and put it on a suitable surface,
2. Remove the front and rear covers,
2
Release the upper tab, then the side
tab. Remove the front cover.
Upper tab
1
Side tab
Remove 1 screw.
Figure 1 Inserter Front and Rear Covers
Replacement
Reverse the removal procedures to replace the Inserter front and rear covers.
ColorQube® 9303 Family
WARNING
WARNING
GP 14. Disconnect the power cord
REP 12.82-171.
Figure 1.
Upper tab
4
Release the upper
3
tab and side tab,
Remove 1 screw.
then remove the rear
cover.
REP 12.84-171 Inserter Motor
Parts List on PL 12.315.
Removal
Take care during this procedure. Sharp edges may be present that can cause injury.
Switch off the electricity to the machine. Refer to
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
1. Remove the Inserter rear cover, and open the top left door,
2. Remove the inserter motor and bracket,
1
Disconnect motor
harness.
Replacement
1. Reverse the removal procedures to replace the Inserter motor.
2. Make sure that the correct screws are used to replace the inserter motor.
February 2013
4-227
WARNING
WARNING
GP 14. Disconnect the power cord
REP 12.83-171.
Figure 1.
3
2
Remove motor and
Remove 3 screws.
bracket.
Figure 1 Inserter Motor
Repairs/Adjustments
REP 12.83-171, REP 12.84-171