Rep 81.3 Bypass Module - Xerox ColorQube 9303 Series Service Manual

4. Disconnect the harness, Figure 2.
Figure 2 Disconnect harness
Replacement
Replacement is the reverse of the removal procedure.
1. Install the paper feed assembly and push the tray in slowly.
NOTE: Check that the tray does not touch the feed assembly.
2. If a new feed roll assembly is installed, reset the tray 3 feed count to zero. Refer to
CRU / HFSI Status.
ColorQube® 9303 Family
1
Disconnect the harness
then slide the feed
assembly out.
dC135
February 2013
4-289

REP 81.3 Bypass Module

Parts List on PL 70.30
Removal
Switch off the electricity to the machine. Refer to
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
Take care during this procedure. Sharp edges may be present that can cause injury.
Take care when removing the cover. The clips that secure the latch are easily broken.
1. Remove the bypass upper left door cover,
Latch. See CAUTION.
2
Remove 2 screws.
Figure 1 Bypass cover
2. Remove the left cover, PL 81.10 Item 2
WARNING
GP 14. Disconnect the power cord
WARNING
CAUTION
Figure 1.
1
Remove 2 screws, then
remove the top cover
5
Remove the upper
left door cover
4
Release the top
clip, then remove
the cover.
3
Remove 2 screws.
Repairs/Adjustments
REP 81.2, REP 81.3