Figure 2 Harness routing
General Procedures/Information
GP 28, GP 29
GP 29 Component Locations
Purpose
•
To identify the locations of major assemblies within the machine
•
To identify the locations of rollers, sensors and jam zones along the paper path.
Refer to the relevant section:
•
Front Component Location
•
Rear Component Location
•
Roller Locations, Sensor Locations and Jam Zones
•
Document Handler (DADH)
•
Low Capacity Stapler Stacker (LCSS)
•
High Volume Finisher (HVF)
February 2013
6-82
ColorQube® 9303 Family