Xerox ColorQube 9303 Series Service Manual page 1026

4. Remove the pulley carriers and pass the cables through the base of the tray,
NOTE: Short cable over the outer pulley and the long cable over the inner pulley.
Long cable
Figure 2 Remove front elevator cables
Repairs/Adjustments
REP 73.3
Figure 2. 5. Remove the tray 3 rear elevator cable,
Pulley carriers
Short cable
Replacement
The replacement is the reverse of the removal procedure.
Tray 3 front cables.
1. Thread the front short cable (silver) over the inner groove on the pulley
2. Thread the front long cable (yellow) over the outer groove on the pulley.
Tray 3 rear cable.
• Thread the rear cable (black) over the inner groove on the pulley.
February 2013
4-268
Figure
2
Remove the metal plate if
fitted
1
Remove E-clip
Figure 3 Tray 3 rear cable removal
3.
3
Remove the pulley
carrier
4
Remove the drive
dog and cap
5
Remove the cable from
the drive pulley.
6
Pass cable through the
base of the tray
ColorQube® 9303 Family