Xerox ColorQube 9303 Series Service Manual page 913

REP 12.26-171 Back Stop Drive Assembly
Parts List on PL 12.165.
Purpose
This procedure is used to repair the following components:
• BM backstop link springs, PL 12.160 Item
• BM backstop link, PL 12.160 Item 16.
• BM backstop drive shaft, PL 12.165 Item
• BM backstop belt, PL 12.160 Item 7.
• BM back stop bearing, PL 12.160 Item
• BM back stop idler bracket, PL 12.160 Item
Removal
Take care during this procedure. Sharp edges may be present that can cause injury.
Switch off the electricity to the machine
tomer supply while performing tasks that do not need electricity. Electricity can cause
death or injury. Moving parts can cause injury.
1. Open the HVF BM front door and fully pull out the BM module.
2. Remove the crease blade knob (6d),
3. Remove the crease roll handle (6c),
4. Remove the BM front cover, PL 12.150 Item
5. Remove the LH frame plate, PL 12.155 Item
6. Remove the BM tamper assembly,
7. Remove the backstop motor assembly,
8. Remove the backstop assembly, REP
9. Remove the crease blade assembly,
10. Figure 1, remove the BM backstop drive shaft and bearings.
ColorQube® 9303 Family
15.
14.
11.
12.
WARNING
WARNING
GP 14. Disconnect the power cord from the cus-
PL 12.150 Item 4.
PL 12.150 Item 5.
3.
2.
REP 12.30-171.
REP 12.20-171.
12.21-171.
REP 12.36-171.
4
3
Remove the
Remove KL-clip
drive shaft.
and bearing.
February 2013
4-155
1
Remove E-clip
and bearing.
Figure 1 Drive shaft removal
REP 12.26-171
2
Remove KL-clip
and pulley.
Repairs/Adjustments