Xerox ColorQube 9303 Series Service Manual page 1002

1
Remove 2 screws, then push
the scanner to the rear to
unlatch it.
Figure 2 Scanner module removal
8. If a replacement scanner is to be installed, remove the following components:
Repairs/Adjustments
REP 62.1
3
Remove the scanner module.
Replacement
1.
2.
2
Slide the scanner mod-
ule off the 2 docking pins
and the 4 base retainers.
February 2013
4-244
a. Remove the scanner rear cover, PL 62.10 Item
b. Remove the scanner side cover, PL 62.10 Item
c. Remove the user interface assembly,
The replacement procedure is the reverse of the removal procedure.
Ensure that the SBC PWB and power distribution PWB harnesses are correctly wound
round the post, Figure 3.
Figure 3 Harness winding
14.
15.
REP 2.1.
1
Wind the harnesses around
the post as shown.
2
Route the PJs underneath
the harness, then connect
the PJs.
ColorQube® 9303 Family