Table of Contents
Advertisement
13.
Figure
4, remove the BM backstop belt.
1
Remove KL-clip, tensioner
link and bearing.
3
Remove the belt.
Figure 4 Backstop belt removal
Replacement
Reverse the removal procedure to replace the removed components. Allow the BM backstop
belt to be tensioned correctly before the bracket assembly securing screws are tightened.
Refer to
Figure
3.
ColorQube® 9303 Family
REP 12.27-171 BM Staple Heads
Parts List on
Removal
2
Take care during this procedure. Sharp edges may be present that can cause injury.
Slide the shaft
to one side.
Switch off the electricity to the machine
tomer supply while performing tasks that do not need electricity. Electricity can cause
death or injury. Moving parts can cause injury.
1.
Fully pull out the BM module.
2.
Remove the relevant staple head cover,
3.
Pull the stapler bracket handle,
NOTE: If a 5.5 mm socket and short extension is not available or access to the staple head
securing screws is difficult, remove the BM stapler bracket assembly,
remove the relevant staple head.
4.
Figure
1, remove the relevant staple head.
February 2013
4-157
PL
12.185.
WARNING
WARNING
GP
14. Disconnect the power cord from the cus-
PL 12.185 Item
PL 12.185 Item
9. Open the staplers fully.
REP 12.26-171, REP 12.27-171
14.
REP
12.28-171, then
Repairs/Adjustments
Advertisement
Chapters
Table of Contents
