Rep 91.12 Purge Line Filter - Xerox ColorQube 9303 Series Service Manual

Take care not to insert twists into the cable during installation.
3. Install the service loop using the slides as a guide,
2
Lay the service loop in its home position as
shown, then replace the cable clamps.
Figure 3 Service loop replacement
4. Check the operation of the marking unit slides before replacing the marking unit assem-
bly. Ensure it fully extends and that the service loop does not get trapped when the slides
are returned into the machine.
ColorQube® 9303 Family
CAUTION
Figure 3.
1
Screw the service loop
to the draw slide.

REP 91.12 Purge Line Filter

Parts List on PL 91.20
Removal
Switch off the electricity to the machine. Refer to
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
Take care during this procedure. Sharp edges may be present that can cause injury.
Do not touch the exposed face of the printheads. Surface contamination or minor damage can
destroy the printhead.
1. Remove the printheads,
2. Remove the purge line filter,
1
Push forward from the
rear then lift at the front.
Figure 1 Purge line filter removal
Replacement
1. Replacement is the reverse of the removal procedure.
February 2013
4-337
WARNING
GP 14. Disconnect the power cord
WARNING
CAUTION
REP 91.29.
Figure 1.
2
Disconnect the air
tube.
REP 91.11, REP 91.12
Repairs/Adjustments