Gp 27 Cleaning Procedure - Xerox ColorQube 9303 Series Service Manual

GP 27 Cleaning Procedure

Purpose
Use this procedure when cleaning is required.
Procedure
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to GP 14. Disconnect the power cord. Electricity can cause
death or injury. Moving parts can cause injury.
Wear protective gloves when using solvents and cleaning agents,
After correcting all causes of contamination perform any of the following procedures as
required:
• Oil Spillage
• Drum Fan Shroud and Drum Belt
• Upper Baffle
• Transfix Stripper Assembly
• Pre Transfix Sensor (20)
• DADH
• Optics
• Paper Trays and Feed Rolls
• Internal Cleaning
• Vertical Paper Path
• Horizontal Paper Path
• Registration / Preheat Assembly
• Marking Unit
• Drum
• Transfix Roller
• Stripper Gate and Baffle
• IOD
• Cleaning Unit and Abatement Plenum
Oil Spillage
Go to the relevant procedure:
• Floor Spillage
• Machine Spillage
Floor Spillage
Materials:
• Cleaning cloth, PL 26.11 Item 9.
• Safety glasses, PL 26.11 Item 7.
• Nitrile gloves, PL 26.10 Item 5.
General Procedures/Information
GP 27
WARNING
WARNING
PL 26.10 Item
Immediately clean an oil spill. Spilt oil is a slip hazard. Do not walk in the contaminated
area. Walking in the contaminated area will spread the contamination and contaminate
footwear. Contaminated footwear is a slip hazard.
Do not attempt to mop up the spilt oil with conventional mops and water. This will
spread the contamination and will extend the slip hazard.
Procedure
1. Close off the contaminated area. If available place warning signs around the area.
2. Use a dry cloth, paper towel or cleaning cloth to blot any residue.
3. Remove all visible material by blotting instead of rubbing.
5.
4. Inform the customer of the spillage.
5. Refer to your local process regarding cleaning spillage / customer compensation.
6. Dispose of all contaminated towels in a covered metal container.
Machine Spillage
Materials:
• Silicon oil removal kit,
Wear the protective gloves included in the silicon oil removal kit when using the syringe
to remove the oil.
Ensure that the cleaning unit is kept level on removal to avoid oil spillage.
Procedure
1. Close off the contaminated area. If available, place warning signs around the area.
2. Place the absorbent fabric mat on the floor in front of the machine to catch drips when the
cleaning unit is removed.
3. Check the 3 tray horizontal transport assembly
spillage, discard any damaged media and remove oil from the trays using a cleaning
cloth.
4. Ensuring that it remains level to avoid oil spillage, remove the cleaning unit and place
directly onto the absorbent fabric mat.
5. Remove as much oil as possible from the drip tray with a syringe and empty into the con-
tainer.
6. When no more silicon oil can be removed using the syringe, remove the remaining oil
using cleaning cloths.
7. Ensure the area around the machine has no residual silicon oil and that spillages are thor-
oughly cleaned up.
8. Dispose of the oil in the container and the absorbent material in accordance with safety
guidelines.
Drum Fan Shroud and Drum Belt
The drum shroud is a HFSI and must be cleaned at regular intervals, refer to
system Maintenance. To reset the HSFI count, go to dC135.
February 2013
6-78
WARNING
WARNING
PL 31.11 Item 32.
WARNING
CAUTION
PL 81.35 Item 1 and trays 1 and 2 for oil
SCP 4 Sub-
ColorQube® 9303 Family