Xerox ColorQube 9303 Series Service Manual page 987

REP 12.86-171 Inserter Clutch
Parts List on PL 12.310.
Removal
Take care during this procedure. Sharp edges may be present that can cause injury.
Switch off the electricity to the machine. Refer to
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
1. Remove the Inserter rear cover. REP
2. Remove the inserter clutch, Figure
NOTE: The reverse roll drive idler and the drive belt are not attached to the clutch bracket
or the Inserter frame.
1
Remove the E-clip
and bearing.
FOR CLARITY
INSERTER MOTOR
Reverse roll drive
NOT SHOWN
idler
Figure 1 Inserter Clutch Removal
ColorQube® 9303 Family
WARNING
WARNING
GP 14. Disconnect the power cord
12.83-171.
1.
2
Remove 4 screws, then the bracket.
3
Disconnect the con-
nector, then remove
the inserter clutch.
Reverse roll drive
belt
Reverse roll drive
pulley
Replacement
1. Reverse the removal procedures to replace the Inserter clutch.
2. When replacing the bracket, check that the clutch torque arm locates in the locating tab.
3. Put the reverse roll drive belt over the drive idler and check that the reverse roll idler gear
shaft locates properly into the frame.
4. When the bracket is secured, temporarily remove the circlip and the reverse roll drive pul-
ley to replace the drive belt over the reverse roll drive pulley.
February 2013
4-229
Repairs/Adjustments
REP 12.86-171