Xerox ColorQube 9303 Series Service Manual page 916

3
Using a 5.5 mm socket
and short extension fully
loosen the screw until the
staple head is released.
Leave the socket and
extension in position on
the screw.
Figure 1 Staple head removal
Repairs/Adjustments
REP 12.27-171
2
Loosen 1 screw
using a 5.5 mm
socket and
ratchet driver.
4
1
Disconnect the
Remove 2 screws
stapler harness
using a 5.5 mm
and remove the
socket and
stapler.
ratchet driver.
February 2013
Replacement
1. Reverse the removal procedure to replace the BM staple heads.
2. Perform ADJ 12.3-171, Stapler Anvil Alignment.
4-158 ColorQube® 9303 Family