Rep 12.18-171 Bm Crease Blade Motor - Xerox ColorQube 9303 Series Service Manual

REP 12.18-171 BM Crease Blade Motor

Parts List on PL 12.170.
Purpose
This procedure is used to repair the following components:
• BM crease blade motor encoder sensor,
• BM crease blade motor, PL 12.170 Item
• Motor encoder, PL 12.170 Item 4.
• Bearing, PL 12.120 Item 7.
• Crank, PL 12.170 Item 8.
Removal
Take care during this procedure. Sharp edges may be present that can cause injury.
Switch off the electricity to the machine
tomer supply while performing tasks that do not need electricity. Electricity can cause
death or injury. Moving parts can cause injury.
1. Open the HVF BM front door and fully pull out the BM module.
2. Remove the crease blade knob (6d),
3. Remove the crease roll handle (6c),
4. Remove the BM front cover, PL 12.150 Item
5. Remove the left frame plate, PL 12.155 Item
6. Remove the motor cover, PL 12.170 Item
open ended spanner, this means the removal of the BM PWB is not necessary.
Repairs/Adjustments
REP 12.18-171
PL 12.170 Item 1.
3.
WARNING
WARNING
GP 14. Disconnect the power cord from the cus-
PL 12.150 Item 4.
PL 12.150 Item 5.
3.
2.
11. It is easier to remove the screw using an
February 2013
4-144 ColorQube® 9303 Family