Xerox ColorQube 9303 Series Service Manual page 992

REP 12.93-171 Inserter LE and TE Sensors
Parts List on PL 12.310.
Removal
Take care during this procedure. Sharp edges may be present that can cause injury.
Switch off the electricity to the machine. Refer to
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
1. Remove the Inserter front and rear covers,
2. Remove the inserter motor, REP 12.84-171.
3. Remove the pickup roll assembly, REP
4. Remove the top cover, REP 12.91-171.
5. Remove the top inside cover, REP
6. Remove the LE sensor or TE sensor,
3
Disconnect the harness,
then remove the relevant
sensor.
Figure 1 LE and TE Sensors
Repairs/Adjustments
REP 12.93-171
WARNING
WARNING
GP 14. Disconnect the power cord
REP 12.83-171.
12.95-171.
12.88-171.
Figure 1.
Idle Roll Assembly
1
Release the har-
ness clips.
2
Remove 1 screw, then
the sensor bracket.
Replacement
Reverse the removal procedure to replace the LE and TE paper path sensors.
February 2013
4-234 ColorQube® 9303 Family